Custom 3D-Printed Nikko Transmission Mount Gearbox Pivot for R/C Frame Buggy. You will receive one set. One Right, One Left
Nikko Frame Buggy Transmission Pivots. These mount the Transmission/Gear Box to the Frame on many Nikko / Radio Shack Buggies
Should Fit these models and maybe more:
Nikko Rhino, Nikko Bison, Rhino, Thunderbolt F10, Radio Shack Golden Arrow, Sears Lobo
Installation Notes: Only experienced model hobbyist should buy these. These buggies are Toy Grade RTR and were not meant to be disassembled. Most of these buggies have a pressed on collar that must be removed to take out pivot pin. Do this at your own risk! I remove this collar by clamping the collar in a bench vice and use a punch that is a little smaller than the axle to tap it out with a hammer.
IMPORTANT NOTICE about QUALITY & COLOR: I am a Vintage R/C enthusiast who makes these for the good of all Nikko R/C Buggy Fans. I personally design and make these from scratch! I have lots of happy buyers, and I use these on my personal collection of Nikko R/C Buggies. Even though they are printed in PLA, they seem to be even stronger than the originals because my design is better. I am happy with them and I hope you are too. They are 3D-Printed so there will be small imperfections. These are not an exact replica of the originals! These are a replacement parts.
- Scale: 1/12
- Material: PLA
- 37.8 mm x 27.8 mm x 8.6 mm